HPI102772

HPI SFL-11MG SERVO(METAL GEAR/24.7kg-cm6.0V)

High Torque Servo/Futaba J Connector/Metal Output Gear
Standard Parts

Dramatically increase the strength of your steering with the SFL-11MG servo, which is fitted with metal gears for extra power!

This is a 1/5th scale large-size servo with a surprising amount of power available: nearly 25kg-cm at 6 volts, making it ideal for single-servo control of the Baja buggy and truck front wheels!

Note: this servo requires a 25-tooth servo horn/arm, which may be different than the servo you are replacing in your HPI kit.

NOTE: NOT WATERPROOF! Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant – we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.

Past op :
Baja 5B GAS SBK
Baja 5B FLUX SBK